1·The reinforcement bars are soldered on the external sides of the columns.
吊勾焊接在立柱上或焊接在加强板上。
2·For other varieties of steel elements like reinforcement bars the recycling rate is a bit lower at 65%.
其他品种的钢材元素，如钢筋的再循环率相对较低为65 %。
3·In fact, he said, Roman structures that rely on the arch for strength can far outlast modern concrete buildings that rely on steel reinforcement bars, which eventually corrode.
实际上，他说，罗马结构依赖于高强度的拱，寿命远长于现代的依靠钢强化的混凝土建筑，而钢结构最终被腐蚀。
4·The design methods of it are presented, including grouting holes radius and location, material ratio and length of reinforcement bars and holes, inter-relations of them are included too.
介绍注浆和锚固钢筋的设计，包括注浆半径、注浆孔的布置、注浆材料的配和比，以及钢筋和注浆孔的长度及相互间的位置关系。
5·As an alternative they may be anchored as straight bars, but links should be provided as confining reinforcement.
在选择时，一般采用直杆锚固，铰接用于加固限制。
6·The additional transverse reinforcement should be uniformly distributed in the anchorage zone and the spacing of bars should not exceed 5 times the diameter of the longitudinal reinforcement.
增加横向钢筋应均匀分布在锚固区和搭接的间距应不超过5倍的纵向钢筋直径。
7·According to the features of reinforcing bars in the wall, authors model the combing material model of reinforcement and concrete and get the calculation formulation of a stiffness matrix.
根据框支墙中钢筋的特点，确定了钢筋与混凝土的材料组合模型，导出刚度矩阵的计算公式。使框支剪力墙结构的非线性有限条法分析成为可能。
8·Two failure models of composite soil stability with sttel bar reinforcement and four failure models of steel bars and the soils are shown in the paper.
提出插筋复合土体边坡二种破坏模式和杆筋与杆间土间的四种破坏模式。
9·Embedded bars reinforcing is a new post-reinforced masonry wall reinforcement technique.
嵌筋加固是一种新型后配筋砌体的墙体加固技术。
10·Based on comparison of strength, ductility, anchorage property and construction adaptation of steel bars in reinforcement concrete, the proposal of optimization for steel bars has been proposed.
从钢筋强度、延性、锚固性能以及施工适应性等几方面，比较了我国现有各种钢筋的特点，并提出了优化我国混凝土用钢筋的建议。